- Customer Support
- Technical Papers
- Basic Guide to Particle Counting
- Technical Support
- Service/Calibration Scheduling
- FAQ
- Airborne Particles
- Liquid Particles
- Is it possible to perform in line particle counting in a emulsion when passing through a pipe at 450 litres / minute?
- Bubbles
- CLS Height
- Flow rate
- PSLs
- Particle Distributions
- Plumb
- Post Service
- Stable counts
- Statistically valid
- Surfactants
- Surfactant miscibiity
- Colored Chemical
- Cleaning
- Compression Sampler Settings
- DC Light
- Software
- LaminarCabinet
- Counts/mL Reading
- APSS 200 parameters
- Particles per mL
- Liquistat Nitrogen needed
- HSLIS Pressure
- Pharmaceutical/Life Sciences Particle Counting
- Microbial
- Particle Counter Service
- Molecular Monitoring
- Gas Analysis
- Software
- General
- Newsletters
- Store
- Particle Counters
- Microbial Air Samplers
- Molecular Monitors
- Services
- Rentals / Leasing
- Company News
FAQ - Liquid Particles
Submit a New QuestionLiquid Particle Counter
- Question
How important is it to maintain the specified flow rate of my particle counter? - Answer
Flow rate effects the transit time of particles across the laser, therefore, each instrument is calibrated to a specific flow. Running the instrument above or below the specified flow rate can cause over and under counting and over and under sizing.
Privacy
content Copyright © 2002-2008 Particle Measuring Systems, Inc.
Information on this website is subject to change without notice.
