Preguntas frecuentes Contador de partículas de líquidos

• Is it possible to perform in line particle counting in a emulsion when passing through a pipe at 450 litres / minute?
• What is the appropriate sample height when using a CLS liquid particle counter?
• How should I plumb my in-line particle counter?
• ¿Cuánto tiempo tardarán mis conteos de partículas en estabilizarse una vez que se conecta mi contador de partículas?
• How many samples do I need to insure statistically valid data?
• How important is it to maintain the specified flow rate of my particle counter?
• I just received my liquid particle counter from Service. What steps should I take before I start my normal sampling?
• ¿Cuáles son algunas de las distribuciones de partículas características?
• ¿Qué son las PSL?
• Bubbles in my solution result in imperfections in my product. Is there a particle counter that can measure them?
• How long will it take for my particle counts to stabilize once my particle counter is connected?
• I have surfactant in my solution; will my particle counter mistake bubbles for particles?
• What is Surfactant miscibility and how is it relevant to particle counting?
• My chemistry is viscous and colored; how will this affect the particle counts?
• What steps should I take between samples to clean my particle counter?
• I have a compression sampler, how do I optimize the settings?
• Which software should I use for my application?
• I am seeing high DC light, what could be the problem?
• We can not get a zero count reading for our APSS 200; the analysis is carried out under laminar class I cabinet. What could be the reason?
• If we set the data as counts per ml (normalized count), then the will the reading be interpreted as counts/ml directly? or what is the difference between raw count and normalized count?
• What are the environmental conditions and calibration parameters for particle counter APSS 200 liquid sampler?
• Do I need cumulative or differential data to determine the number of particle per ml of the product?
• What average flow rate/ consumption for nitrogen purge gas is to expect for a Liquistat?
• What is the optimum operating pressure for the HSLIS M65e particle counter? i.e. the incoming chemical at the inlet.